70 New: Autosoft

Clean the area with an alcohol swab. Unlike the old version, the new adhesive requires completely dry skin to bond effectively. Wait 60 seconds after swabbing.

Place the inserter flat against the skin. Press the two release buttons simultaneously. You will hear a soft thump . Hold the inserter against the skin for 3 seconds—this is critical for the new adhesive to form a micro-seal. autosoft 70 new

While the original Autosoft 70 relied on a manual insertion device with a visible needle, the version focuses on improved occlusion detection and a revised adhesive patch designed to withstand showers, exercise, and humid environments. Key Features of the Autosoft 70 New Tandem Diabetes has strategically upgraded three core areas: the inserter mechanism, the adhesive technology, and the cannula flexibility. 1. Upgraded Inserter Comfort The most noticeable change in the Autosoft 70 new is the redesigned insertion device. The spring-loaded mechanism now features a softer "landing" pad that reduces the jarring sensation of the needle retraction. Users report that the new inserter is quieter and less intimidating than previous models or competitive 90-degree sets. The viewing window has also been enlarged, allowing users to clearly verify that the cannula has fully deployed into the subcutaneous tissue before removing the inserter. 2. Advanced Adhesive with Tape Extension One of the top complaints about older infusion sets was edge lifting. The Autosoft 70 new employs a 3D-printed adhesive matrix that contours to skin folds. It also includes an integrated tape extension tab—a small fabric strip that allows users to secure the set against the skin without needing additional overtape. This is particularly beneficial for active individuals or those living in hot climates where sweat degrades adhesives. 3. Enhanced Occlusion Resistance Occlusions (blockages in the cannula) are a nightmare for pump users, leading to missed insulin and high blood sugars. The new Autosoft 70 features a dual-lumen cannula design near the base. This reduces the "tip curl" that sometimes occurred with the older soft cannulas, ensuring insulin flows freely even after 48 to 72 hours of wear. Autosoft 70 New vs. Autosoft 90 (Original) Many distributors still sell the original Autosoft 90, so knowing the difference is critical. Clean the area with an alcohol swab

| Feature | Original Autosoft 90 | | | :--- | :--- | :--- | | Tubing Length | 70cm | 70cm (Same) | | Inserter Noise | Audible "pop" | Dampened "click" | | Adhesive Layer | Standard white patch | Textured, breathable patch with tape tab | | Cannula Material | Standard PTFE | Reinforced PTFE (anti-kink) | | Needle Gauge | 29g introducer | 29g introducer (Sharper bevel) | | Sterile Packaging | Paper/Pouch | Reinforced peel-pouch | Place the inserter flat against the skin

Remove the paper liner from the adhesive. Slide the connector into the inserter device until it clicks. Do not pull off the needle cover until you are ready to insert.